Skip to Content.
Sympa Menu

cgal-discuss - Re: [cgal-discuss] Remeshing of manifolds with border?

Subject: CGAL users discussion list

List archive

Re: [cgal-discuss] Remeshing of manifolds with border?


Chronological Thread 
  • From: "Maarten Moesen" <>
  • To:
  • Subject: Re: [cgal-discuss] Remeshing of manifolds with border?
  • Date: Thu, 14 Dec 2006 16:49:12 +0100
  • Organization: KULeuven

Hello,

Polyhedral surfaces with constrained edges are our first target.
However, and it will take us a few months to come out with something working for such surfaces.

OK, I'll be glad to hear from you.
I'm currently working myself on 'smoothing' the surfaces a little and getting rid of short and unnecessary sharp edges. This will make life for the mesher probably a lot easier ;)

Thank you very much for your reply!

Maarten Moesen

--
ir. Maarten Moesen
Department of Metallurgy and Materials Engineering (MTM)
K.U.Leuven
Kasteelpark Arenberg 44
B-3001 Heverlee, Belgium
tel. +32 (0)16 32 13 17
fax. +32 (0)16 32 19 90

Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm




Archive powered by MHonArc 2.6.16.

Top of Page